PR/GT Knot Tying Tool for Braid to Leader Connections

PE Line Leader Knotter Tool

• Suitable for tying GT, FG, and PR knots easily.
• Polished smooth finish to protect lines from damage.

Product Parameters

• Total height: 84 mm
• Needle length: 48 mm
• Spool diameter: 28 mm (outer), 20 mm (inner)
• Spool width: 34 mm

Product Detail Callouts

• Stainless steel line guide tube with adjustable length screw knob.
• Line spool groove and line stop groove designed on the main body.
• Drag adjustment knob: turn clockwise to increase drag resistance, counterclockwise to decrease drag resistance.

Guide Tube Full Upgrade

• Polished stainless steel tube prevents line damage and breakage

Rubber Line Slot Design

• Dual rubber O-ring design securely fixes fishing line without slipping
• Durable, wear-resistant rubber tightens the line without causing damage

Knob-Style Drag Adjustment Design

• Anti-slip knurled thread design allows precise line output speed adjustment for even knotting.
• Turn clockwise to tighten and precisely adjust resistance/drag.
• Turn counterclockwise to loosen for smooth and effortless operation.

Hardcore Material Construction

• Selected aluminum alloy combined with stainless steel
• Aluminum alloy construction provides lightweight yet high strength
• Stainless steel components offer corrosion resistance and wear resistance

Instructions for Use

• Thread the PE line through the metal guide tube.
• Secure the PE line in the line clamp slot.
• Wrap the PE line around the spool line slot 15-20 turns.
• Adjust the tension knob to a suitable tightness (do not over-loosen to prevent detachment during knotting).
• Pull the PE line tight and adjust to a suitable length (approx. 30 cm / 12 in).
• Hold the PE line and fluorocarbon leader line together and wrap around your right hand.

Knotting Tool Instructions

• Wrap the other end of the fluorocarbon line around your left hand, placing the tip of the threading tube near your right index finger.
• Rotate the knotting tool to wrap the PE line around the fluorocarbon line, using your hand to assist in wrapping 4-5 turns.
• After wrapping 4-5 turns of PE line around the fluorocarbon line, hold the line end with your thumb and wrap in the opposite direction.
• After assisting with wrapping 4-5 turns, rotate the knotting tool and continue wrapping.

Knotting Instructions

• Wrap to the appropriate length, approximately 8–12 cm.
• Remove the excess line from the knotter or cut it off, leaving about 30 cm reserved.
• Use the cut PE line end to tie knots around the fluorocarbon line about 4–6 times, then trim close to the fluorocarbon line.
• Use a lighter to heat and melt the reserved fluorocarbon end, burning off the tag end.
• Continue tying 6–8 knots with the cut PE line around the main PE line.
• Knot to a suitable tightness, ensuring the finishing knots are snug with no gaps, then singe the line end to finish.